113-0296-40 +.040" Ring Set for P224G Spec B C & D Also T260G

One ring set required per piston.

Measure Your Original Parts Prior To Placing An Order.

For Gas Engines Only

The compression rings here are the same thickness as a NICKEL. If a nickel fits nice in the top two piston grooves you most likely are on the right page.

If a PENNY is sloppy in those top grooves you are most likely on the right page.

If a PENNY does FIT nicely in the TOP grooves you are on the WRONG page.


113-0296-40 +.040" Oversize Ring Set for P224G Specs B C & D. Also T260G and some "N" series. NHC Beginning with spec D. NHD spec A-E. NHE spec D-H. Bore size 3 9/16 or 3.560

The ring thickness is as follows:

Top: 5/64 or .078" or 2.0 MM

Second: 5/64 or .078" or 2.0 MM

Oil ring: 3/16 or .186" or 4.75 MM

Onan used two ring styles on the P224G engine.

Beginning with spec E on the P224G the compression ring thickness is .058" and the part number is 113-0311-04.

Part Number 113-0296-40 Supersedes/Replaces Part Number 113-0203-40.

If your T260G has had the pistons replaced and the compression ring thickness is .058" then use ring set 113-0311-04

Models listed are for general reference only and do not guarantee this part will fit your specific application.

Checking the correct parts manual and comparing the old part to the new one if pictured is the buyers responsibility, not ours. Once placed, all sales are final.

No Returns on Electrical Parts.

IF ITEM SHOWS SOLD OUT, Please CONTACT US for availability and/or back order status. We get busy at times, if a part is listed as sold out please inquire about it as our website may not reflect current stocking levels.